How To Generate a Remote Access Link

1. Navigate to https://yourpbxFQDN.com/#/office/dashboard

2. Click "Remote Access"

3. Click "Generate Link"

4. Click this icon.

• Related Articles

• Configure Remote User Access using OpenVPN

  Introduction Besides being able to use PPTP and L2TP with IPsec you can now also use OpenVPN for Remote User Access to your LAN. This article describes how to configure your Peplink router and a Windows 10 client for remote User Access using OpenVPN. ...

• Creating an IPSEC on fortigate

  1. Login to the FortiGate and go to  VPN -> IPsec Tunnels, then select "Create New" 2. Start off using the Site-to-Site configuration, this will automatically create Static Routes and Policys for you. 3. Enter the IP address of your Telin hosted PBX. ...

• Creating IPSEC on Peplink

  1.  Login to your Peplink device, either via public IP access or inControl. 2. Click on Network -> Than on the left side "IPsec VPN" -> Than click "New Profile"   3. Fill out the information based on the VPN configuration that Telin provided for your ...

• One Fax- Branding and Domain Setup

  Branding and Domain Setup This article will demonstrate how to set up your branding page and domains. First, click your initials in the bottom left part of the screen, then click branding. The customization tab allows you to add email addresses that ...

• VoIP Security

  Call fraud can be to any destination, but it usually involves toll fraud: a situation in which your VoIP system is hacked and used to make lots of unauthorized international calls to locations that cost alot of money at a very rapid rate. Here is a ...